Ricoh Aficio 8060 - Manual (Page 67)

Messages Displayed When Using the Printer Function
59
4
Failed to obtain
file system.
PDF direct printing could
not be performed because
the file system could not be
obtained. In [Printer Features], under [System],
set [Memory Usage] to [Font Priority].
File system is
full.
PDF file do not print out
because the capacity of file
system is full. Delete all unnecessary files from the
hard disk, or decrease the file size
sent to the machine.
HDD is full. The HDD became full
while printing a Sample
Print, Locked Print, Hold
Print or Stored Print file. Delete unneeded files stored in the
machine.
Alternatively, reduce the data size of
the Sample Print, Locked Print, Hold
Print or Stored Print file.
HDD is full. When printing with the
PostScript 3 printer driver,
the HDD's capacity for
fonts and forms has been
exceeded. Delete unneeded forms or fonts reg-
istered in the machine.
Hardware Problem:
Ethernet
An error has occurred in
the Ethernet board. Turn off the main power switch, and
back on again. If the message ap-
pears again, contact your service
representative.
Hardware Problem:
HDD
An error has occurred in
the hard disk drive. Turn off the main power switch, and
back on again. If the message ap-
pears again, contact your service
representative.
Hardware Problem:
Parallel I/F
An error has occurred in
the parallel interface
board. Turn off the main power switch, and
back on again. If the message ap-
pears again, contact your service
representative.
Hardware Problem:
USB
An error has occurred in
the USB interface. Turn off the main power switch, and
back on again. If the message ap-
pears again, contact your service
representative.
Hardware Problem:
Wireless Board
Access to the wireless
board in which the wire-
less LAN interface unit is
inserted is possible, but an
error was detected. Turn off the machine, and check the
wireless board is inserted correctly.
Then, turn the machine on again. If
the message appears again, call your
service representative.
Hardware Problem:
Wireless Card
• A wireless card that the
machine cannot use has
been installed.
• An error has occurred
with the wireless card.
Turn off the machine, and check the
wireless card. Then, turn the ma-
chine on again. If the message ap-
pears again, call your service
representative.
Message Cause Solution