Roland V-Synth - Manual (Page 12)

12
Panel Descriptions
Front Panel
Volume Slider
Adjusts the overall volume that is output from the rear panel MAIN
OUT jacks and PHONES jack.
→
(Quick Start; p. 4)
INPUT
[PEAK] (Peak Indicator)
This will light when the input volume is too high.
[LEVEL]
Adjusts the volume of the signal input through the INPUT jacks on
the rear panel.
→
(p. 57)
D BEAM
You can apply a variety of effects to sounds simply by moving your
hand.
→
(p. 29)
Indicators (L, R)
If the D Beam controller is on, these will light when you move your
hand over the controller.
[ON/OFF] (TIME TRIP, TIME, PITCH,
ASSIGNABLE)
Switches the D Beam controller on/off. The effect to be controlled
can be selected by pressing the relevant button.
TIME TRIP: Apply the Time Trip effect.
TIME: Apply the Time Control effect.
PITCH: Apply the Pitch Control effect.
ASSIGNABLE: Apply the effect that is specified for each sound.
TIME TRIP PAD
By touching the pad surface with your finger you can apply a variety
of effects to the sound.
Indicator
This will light when you touch the Time Trip Pad.
[TIME TRIP]
Switches to the Time Trip effect.
[ASSIGNABLE]
Switches to the effect that is specified for each patch.
[HOLD]
Switches hold on/off for the effect controlled by the Time Trip pad.
V-LINK
Enables or disables control of an externally connected V-LINK
device.
ASSIGNABLE CONTROL
You can assign a variety of parameters and functions to the two
knobs ([C1], [C2]), and use them to modify the sound in realtime.
→ (p. 30)
ARPEGGIO
Here you can control the arpeggiator.
[TEMPO]
Adjusts the tempo of the arpeggios.
[ON/OFF]
Switches the Arpeggiator on/off.
[HOLD]
Switches the Arpeggiator hold on/off.
1
2
3
4
5
6
7
4
5
8
9
10
1 2 3
6 7
17