Roland V-Synth - Manual (Page 47)

47
Creating a Patch
Creating a Patch
Adjusting the Volume and Pan
(TVA)
TVA Switch ◆
Switches the TVA on/off.
Value: OFF, ON
TVA
fig.03-24_50
Level ★
Specifies the volume of the patch.
Value: 0–127
Level KF (Level Key Follow)
Use this parameter if you want the volume of the patch to change
according to the key that is pressed. Relative to the volume at the C4
key (center C), positive (+) settings will cause the volume to rise for
notes higher than C4, and negative (-) settings will cause the volume
to fall for notes higher than C4. Larger settings will produce greater
change.
Value: -200– +200
Lvl LFO Dp (Level LFO Depth) ★
Specifies how deeply the LFO will affect the volume of the patch.
Value: -63– +63
Pan
Specifies the pan of the patch. “L64” is far left, “0” is center, and
“63R” is far right.
Value: L64–0–63R
Pan KF (Pan Key Follow)
Use this parameter if you want key position to affect panning.
Positive (+) settings will cause notes higher than C4 key (center C) to
be panned increasingly further toward the right, and negative (-)
settings will cause notes higher than C4 key (center C) to be panned
toward the left. Larger settings will produce greater change.
Value: -200– +200
fig.Pan KF.e
Pan LFO Dp (Pan LFO Depth) ★
Specifies how deeply the LFO will affect the pan.
Value: -63– +63
In this screen you can make settings for the envelope that affects
the TVA. For details on envelope settings, refer to
“Making
Envelope Settings” (p. 48).
LFO
fig.03-25_50
In this screen you can make settings for the LFO that affects the
TVA. For details on LFO settings, refer to
“Making LFO
Settings” (p. 49).
C4 C3 C2 C1 C5 C6 C7
0
+50
+100
-50
-100
o
L
R
Pan
Key