Ricoh G700 - Manual (Page 108)

106
A
ppendic
es
11
11 Appendices
Troubleshooting
Error Messages
If an error message is displayed on the screen, check the information
on the reference page and take the corresponding action.
Error Message Cause and Solution Refer to
Insert card. No card is loaded. Insert a card. P.23
Set date. The date is not set. Set the date. P.79
The file number limit has been
exceeded. The file number limit has been exceeded. Use another card. P.79
Unmatched File This file cannot be displayed on the camera. Check the file
contents on your computer, and then delete the file. —
Insufficient memory. Continue? All the files cannot be copied because there is insufficient
memory on the card. Use another card. P.20
Protected The file selected for deletion is protected. P.72
Card Is Write-Protected. The card is locked (write-protected). Unlock the card. P.21
This option is not available with
SD WORM cards. Selected option is not available with SD WORM cards. Use
a different type of card. P.20
Print settings cannot be applied
to this file. This file (movie or other file) cannot be selected for
printing. —
Insufficient Memory/
Capacity Short Files cannot be stored. Make sure there is sufficient
memory or delete unwanted files. P.37,
P.76
The image print number limit has been exceeded. Select an
image and set the number to 0. P.94
Format internal memory. The internal memory requires formatting. P.76
Format card. The card is not formatted. Format the card with this
camera. P.76
Card Error Reformat the card. If the error message still appears after
that, the card may be faulty. Do not use the card. P.76
Writing Data Writing file to memory. Wait until writing finishes. —
No File There are no files that can be played back. —
Out of memory. cannot record. The number of remaining shots is 0. Switch to another card
or the internal memory. P.20
No files to restore. There are no files to restore. P.67
Can not —. * Selected option can not be applied to image more than
once, or image was created with different make of camera.
If image was created with different make of camera,
process image using original make of camera. —
* “—“ indicates the name of the process that can not be applied.