Warranty, The following california air resources board – Ryobi CS30 RY30020A User Manual

Page 25

Advertising
background image

Page 25

RYOBI TECHNOLOGIES, INC. LIMITED WARRANTY FEDERAL AND CALIFORNIA EMISSION

CONTROL SYSTEMS NON-ROAD AND SMALL OFF-ROAD ENGINES

The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Ryobi Technologies, Inc. are pleased

to explain the Emission Control System Warranty on your non-road or small off-road engine. In California, new small off-road engines

must be designed, built and equipped to meet the state’s stringent anti-smog standards. In other states, new 2000 and later model

year non-road engines must be designed, built, and equipped, at the time of sale, to meet the U.S. EPA regulations for small non-road

engines. The non-road engine must be free from defects in materials and workmanship which cause it to fail to conform with U.S. EPA

standards for the first two years of engine use from the date of sale to the ultimate purchaser. Ryobi Technologies, Inc. must warrant

the emission control system on your non-road or small off-road engine for the period of time listed above provided there has been no

abuse, neglect, or improper maintenance of your non-road or small off-road engine.
Your emission control system may include parts such as the carburetor or fuel injection system, the ignition system, and the catalytic

converter. Also included may be hoses, belts and connectors, and other emission related assemblies.
Where a warrantable condition exists, Ryobi Technologies, Inc. will repair your non-road or small off-road engine at no cost to you,

including diagnosis (if the diagnostic work is performed at an authorized dealer), parts, and labor.

MANUFACTURER’S WARRANTY COVERAGE:

The 1995 and later small off-road engines are warranted for two years in California. In other states, 1997 and later model year non-

road engines are also warranted for two years. If any emission-related part on your engine is defective, the part will be repaired or

replaced by Ryobi Technologies, Inc. free of charge.

OWNER’S WARRANTY RESPONSIBILITIES

(a) As the non-road or small off-road engine owner, you are responsible for the performance of required maintenance listed in your

operator’s manual. Ryobi Technologies, Inc. recommends that you retain all receipts covering maintenance on your non-road or

small off-road engine, but Ryobi Technologies, Inc., cannot deny warranty solely for the lack of receipts or for your failure to ensure

the performance of all scheduled maintenance. Any replacement part or service that is equivalent in performance and durability

may be used in non-warranty maintenance or repairs, and shall not reduce the warranty obligations of the engine manufacturer.

(b) As the non-road or small off-road engine owner, you should be aware, however, that Ryobi Technologies, Inc., may deny you

warranty coverage if your non-road or small off-road engine or a part has failed due to abuse, neglect, improper maintenance, or

unapproved modifications.

(c) You are responsible for presenting your non-road or small off-road engine to a Ryobi Technologies, Inc., service dealer as soon as

a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact a Ryobi Technologies, Inc., Customer

Representative at 1-800-860-4050.

COVERAGE:

Ryobi Technologies, Inc. warrants to the ultimate purchaser and each subsequent purchaser that your non-road or small off-road

engine will be designed, built, and equipped, at the time of sale, to meet all applicable regulations. Ryobi Technologies, Inc. also war-

rants to the initial purchaser and each subsequent purchaser that your non-road or small off-road engine is free from defects in mate-

rials and workmanship which cause the engine to fail to conform with applicable regulations for a period of two years. The 1995 and

later small off road engines are warranted for two years in California. In all other states for 1997 and later model years, EPA requires

manufacturers to warrant non-road engines for two years. These warranty periods will begin on the date the non-road or small off-

road engine is purchased by the initial purchaser. If any emission-related part on your engine is defective, the part will be replaced by

Ryobi Technologies, Inc. at no cost to the owner.
Ryobi Technologies, Inc. shall remedy warranty defects at any authorized Ryobi Technologies, Inc. engine dealer or warranty sta-

tion. Any authorized work done at an authorized dealer or warranty station shall be free of charge to the owner if such work deter-

mines that a warranted part is defective. Any manufacturer-approved or equivalent replacement part may be used for any warranty

maintenance or repairs on emission-related parts, and must be provided free of charge to the owner if the part is still under warranty.

Ryobi Technologies, Inc. is liable for damages to other engine components caused by the failure of a warranted part still under warranty.
The California Air Resources Board’s Emission Warranty Parts List specifically defines the emission-related warranted parts. (EPA’s

regulations do not include a parts list, but EPA considers emission-related warranted parts to include all the parts listed below.)
These warranted parts are: Carburetor, Spark Plug, Ignition, Air Filter, and Fuel Filter.

MAINTENANCE REQUIREMENTS

The owner is responsible for the performance of the required maintenance as defined by Ryobi Technologies, Inc. in the operator’s

manual.

LIMITATIONS

The Emission Control Systems Warranty shall not cover any of the following:
(a) repair or replacement required because of misuse or neglect, lack of required maintenance, repairs improperly performed or

replacements not conforming to Ryobi Technologies, Inc. specifications that adversely affect performance and/or durability, and

alterations or modifications not recommended or approved in writing by Ryobi Technologies, Inc., and

(b) replacement of parts and other services and adjustments necessary for required maintenance at and after the first scheduled

replacement point.

The Emissions Compliance Period referred to on the Emissions Compliance label indicates the number of operating hours for which

the engine has been shown to meet Federal emission requirements. Category C=50 hours, B=125 hours, and A=300 hours.

THE FOLLOWING CALIFORNIA AIR RESOURCES BOARD

(CARB) STATEMENT ONLY APPLIES

TO MODEL NUMBERS REQUIRED TO MEET THE CARB REQUIREMENTS.

WARRANTY

Advertising
This manual is related to the following products: