Ricoh PROJECTOR PJ S2130 - Manual (Page 20)

English
19
English
Introduction
Remote Control Battery Installation
Press firmly and
slide the battery
cover off.
1
Slip the cover back over the
batteries until it snaps into
place. Do not mix different
types of batteries or new and
old batteries.
3
Install new batteries (AAA/
R03). Ensure that you have
the batteries’ polarity (+/–)
aligned correctly.
2
To ensure safe operation, please observe the following precautions :
■ Use AAA/R03 type battery.
■ Avoid contact with water or liquid.
■ Do not expose the remote control to moisture or heat.
■ Do not drop the remote control.
■ If the battery has leaked in the remote control, carefully wipe the case clean and
install new battery.
■ Risk of an explosion if battery is replaced by an incorrect type.
■ Dispose of used battery according to the instructions.
■ Remove batteries from remote control when not using for extended periods.
■ The remote control may fail to operate if the infrared remote sensor is exposed to
bright sunlight or fluorescent lighting.
Remote Control Operating Range
Point the remote control
toward the projector (Infra-
red Remote Receiver) when
pressing any button. Maxi-
mum operating range for
the remote control is about
23.0’ (7m) and ±15° in front
of the projector.
23.0’ (7m)
Approx.15°