Ricoh PROJECTOR PJ S2130 - Manual (Page 46)

English
45
English
Appendices
Replacing the lamp
The projector will detect the lamp life itself. It will show you a
warning message
When you see this message, change the lamp as soon as pos-
sible. Make sure the projector has been cooled down for at
least 60 minutes before changing the lamp.
Warning: To avoid
burns, allow the
projector to cool for
at least 60 minutes
before you replace the
lamp!
Warning: To avoid the
risk of personal injury,
do not drop the lamp
module or touch the
glass parts. The glass
parts may shatter and
cause injury if it is
dropped.
Warning: For contin-
ued safety replace with
a lamp of the same
type.
Caution: If the lamp
should break, handle
with care to avoid
injury due to broken
pieces and contact your
sales representative for
repair service.
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the
“Power”.
2. Allow the projector to cool down at least 60 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove the 2 screws from the cover. 
5. Push up and remove the lamp cover.
6. Loosen the 2 screws from the lamp module  and pull up
the lamp bar. 
7. Pull out the lamp module by force. 
8. Install the new lamp module by reversing the previous steps.
See the lamp’s manual for instructions on resetting the lamp
time.
1
2
4
3
Used Lamps 
This projector’s lamp contains trace amounts of environmentally
harmful inorganic mercury. Be careful not to break used lamps,
and dispose of them in accordance with local regulations or con-
tact your sales representative.