Rinnai RHFE-431FA - Manual (Page 24)

– 22 –
FITTING UNIT
AIR INLET HOSE 2. Fit the locking clamp over connection between
sliding tube and manifold. Engage the hook and
rotate it until it snaps against the body of the clamp.
3. Fit the screw clamp between the sliding tube and
the flue elbow. Secure with the 4mm screws
supplied. The flue outlet is now locked into position.
4. Slide the insulation sleeve up to the flue
manifold, slip the securing clip over the sleeve as
shown.
When servicing unit replace plastic tie with new one.
(Available at local hardware store or contact local
distributor.)
LOCKING CLAMP SCREW CLAMP AND
INSULATION.
The following components can be fitted by reaching
down the rear of the appliance as it is positioned
against the wall.
1. Connect the flue outlet to the manifold by
extending the stainless steel sliding tube until it is
fully inserted into the manifold.
Detail of Hose clip
Hose clip
Inlet hose
Manifold
Locking
clamp
Flue outlet
Sliding tube
Manifold
Hook
Locking
Clamp
Flue elbow
Flue Outlet
sliding tube
Manifold
Locking clamp screw Flue Outlet tube
screw clamp
Flue elbow
Sock
Flue outlet
Sliding tube
Slide to here
Fit clip
Slide insulation sock Sliding Tube
Slide
Do not extend flue tube
beyond red line.
Manifold
Inlet hose
Inlet elbow
Plastic tie