Rosewill RNX-G400 User Manual
Page 13
Wireless Router
RNX-G40 User Manual
For Microsoft Windows 2000/XP/Vista:
1.
Click the Start button and select Settings, then click Control Panel. The Control Panel window will
appear.
2.
Move mouse and double-click the right button on Network and Dial-up Connections icon. Move
mouse and double-click the Local Area Connection icon. The Local Area Connection window will
appear. Click Properties button in the Local Area Connection window.
3.
Check the installed list of Network Components. If TCP/IP is not installed, click the Add button to
install it; otherwise go to step 6.
4.
Select Protocol in the Network Component Type dialog box and click Add button.
5.
Select TCP/IP in Microsoft of Select Network Protocol dialog box then click OK button to install the
TCP/IP protocol, it may need the Microsoft Windows CD to complete the installation. Close and go
back to Network dialog box after the TCP/IP installation.
6.
Select TCP/IP and click the properties button on the Network dialog box.
7.
Select Specify an IP address and type in values as following example.
9
IP Address: 192.168.1.1, IP address within the range of 192.168.1.1 to 192.168.1.253 is used to
connect the WLAN AP Router.
9
IP Subnet Mask: 255.255.255.0
For Microsoft Windows NT:
1.
Click the Start button and select Settings, then click Control Panel. The Control Panel window will
appear.
2.
Move mouse and double-click the right button on Network icon. The Network window will appear.
Click Protocol tab from the Network window.
3.
Check the installed list of Network Protocol window. If TCP/IP is not installed, click the Add button
to install it; otherwise go to step 6.
4.
Select Protocol in the Network Component Type dialog box and click Add button.
5.
Select TCP/IP in Microsoft of Select Network Protocol dialog box then click OK button to install the
TCP/IP protocol, it may need the Microsoft Windows CD to complete the installation. Close and go
back to Network dialog box after the TCP/IP installation.
6.
Select TCP/IP and click the properties button on the Network dialog box.
7.
Select Specify an IP address and type in values as following example.
9
IP Address: 192.168.1.1, IP address within the range of 192.168.1.1 to 192.168.1.253 is used to
connect the WLAN AP Router.
9
IP Subnet Mask: 255.255.255.0
8.
Click OK to complete the IP parameters setting.
- 12 -