Rosewill RNX-G400 - Manual (Page 31)

Wireless Router RNX-G40 User Manual
Item Description
IP Address Fill in the IP address of LAN interfaces of this WLAN AP Router.
Subnet Mask Fill in the subnet mask of LAN interfaces of this WLAN AI Router.
Default Gateway Fill in the default gateway for LAN interfaces out going data packets.
DHCP Server
Click to select Disabled, Client or Server in different operation mode of wireless AP
router.
DHCP Client Range
Fill in the start IP address and end IP address to allocate a range of IP addresses;
client with DHCP function set will be assigned an IP address from the range.
Show Client
Click to open the Active DHCP Client Table window that shows the active clients
with their assigned IP address, MAC address and time expired information. [Server
mode only]
802.Id Spanning Tree
Select to enable or disable the IEEE 802.Id Spanning Tree function from pull-down
menu.
Clone MAC Address
Fill in the MAC address that is the MAC address to be cloned. Refer to 4.24 What
is Clone MAC Address?
Apply Changes Click the Apply Changes button to complete the new configuration setting.
Reset
Click the Reset button to abort change and recover the previous configuration
setting.
3.3.11
WAN Interface Setup
This page is used to configure the parameters for wide area network that connects to the WAN port of your
WLAN AP Router. Here you may change the access method to Static IP, DHCP, PPPoE or PPTP by click the
item value of WAN Access Type.
I Static IP
Screen snapshot - WAN Interface Setup - Static IP
- 30 -