RCA 608WL - Manual (Page 125)

Chapter 5
Expert Configuration
E-DOC-CTC-20041126-0013 v1.0
123
System Upgrade The System Upgrade section allows you to manage your SpeedTouch™’s system
software and upload or apply a new system software.
For extended management reasons and roll-back scenarios your SpeedTouch™
provides storage room for two system software packages: the active system
software the SpeedTouch™ is currently running and the passive one.
 The System software properties table provides information on the active
software:
 The Product Name for which the system software is applicable
 The system Software Version
 The Board Type for which the system software is applicable
 The system software File Name (as stored in the SpeedTouch™ storage.
 A link is provided to check for the latest available system software (based on
the information provided in the System software properties table and your
SpeedTouch™’s serial number.
 The Software Versions table allows you to overview the currently stored
active and passive system software and to:
 Upload system software .
 Switch to another system software version .
Upload system software Proceed as follows:
1 Make sure you have a valid system software for your SpeedTouch™ readily
available on your local disk.
2 If a Passive system software version is listed, click Remove Passive to remove
it from the SpeedTouch™ storage.
3 Click Browse... to specify the system software file on your local drive you wish
to upload.
4 Click Upload to upload the system software to your SpeedTouch™.
If the upload was successful the uploaded system software will be listed as Passive
system software version
.
Use the link provided to check for the latest available system software.
!
Uploading system software may take a few minutes. Meanwhile do
not browse to another SpeedTouch™ page in order not to interrupt the
upload process.