RCA 608WL - Manual (Page 194)

Chapter 5
Expert Configuration
E-DOC-CTC-20041126-0013 v1.0
192
Buttons on the Remote
Gateway page
Connection parameters The Connections page contains following parameters:
 Trusted Network
 Protocol
 Port
 IPSec Security Descriptors
Trusted Network The Local and Remote Trusted Network parameters describe which terminals have
access to the secure connection. The Trusted Network IP values are used during the
Phase 1 negotiations, and must comply with the values configured at the remote
Security Gateway.
Protocol You can optionally restrict the IPSec connection to a single protocol. Select any if
you do not want to restrict the connection to a specific protocol.
Port If the tcp or udp protocol is selected for the protocol parameter, then the access to
the IPSec connection can be further restricted to a single port. In almost all cases,
the value any is the most appropriate choice.
IPSec Security
Descriptors
The IPSec Security Descriptor bundles the security parameters used for the Phase 2
Security Association. Pre-configured Security Descriptors can be selected from a list.
Select one that complies with the IPSec security parameters configured in the remote
Gateway.
Click... To...
Stop All Connections to this
Gateway Stop all VPN connections to the selected
remote Security Gateway.
Apply Apply modifications made to the settings
of the selected remote Security Gateway.
Delete Delete the selected remote Security
Gateway from the configuration.
New Gateway Start defining a new remote Security
Gateway.
New Connection to this Gateway Start defining a new connection to the
selected remote Security Gateway.
Status Show the operational status of the
connections to the selected remote Secu-
rity Gateway.
Statistics Show the traffic carried by the VPN
connections to the selected remote Secu-
rity Gateway.
The contents of the IPSec Security Descriptors can be verified via Advanced
> Connections > Security Descriptors
.