Ricoh G1168604A - Manual (Page 83)

Configuration
83
N
Press the {U} or {T} key to display [DHCP], and then press the {# Enter}
key.
O
Press the {U} or {T} key to display [On], and then press the {# Enter} key.
❒ “p” shows the current setting.
❒ After about two seconds, the display returns to the network setup menu.
P
If you use NetWare, select the frame type for NetWare.
Select one of the items below if necessary.
• Auto (Default)
• Ethernet ll
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
❒ Usually, use the default setting (“Auto”). When you first select “Auto”, the
frame type detected by the printer is adopted. If your network can use more
than two frame types, the printer may fail to select the correct frame type if
“Auto” is selected. In this case, select the appropriate frame type.
Q
Press the {U} or {T} key to display [Frame Type (NW)], and then press the
{# Enter} key.
The current setting appears on the display.
R
Press the {U} or {T} key to display the frame type you want to use, and
then press the {# Enter} key.
After the settings are made, about two seconds later, the screen returns to the
network setup menu.
Network Setup:
DHCP
DHCP:
*On
Network Setup:
Frame Type (NW)
Frame Type (NW):
*Auto Select