Radio Shack 15-1925 - Manual (Page 20)

Need help? Call 1-800-950-7044
20
IF YOU HAVE PROBLEMS
MANUAL CODE SEARCH
If the 6 in 1 IR/RF Remote Control does not oper-
ate your remote-controlled devices when you first
set it up, you might have to find the correct code
for your devices. You can try all the codes listed
in the “Manufacturer’s Codes” section on Page 26
for the brand of your device, or you can follow
these steps to search the 6 in 1 IR/RF Remote
Control’s entire library.
1. Manually turn on the device you want to set
up and press the corresponding device key
on your 6 in 1 IR/RF Remote Control (
TV ,
VCR , CBL , CD , and so on).
2. Aim the 6 in 1 IR/RF Remote Control at the
device you want to operate.
3. Hold down SET UP until the red light blinks
twice. Release SET UP and press 9 – 9 – 1 .
The red light blinks twice again.
4. Slowly alternate between PWR and the
device key.
For example, if you are searching for a code
to operate your TV, use the following
sequence.
SET UP – 9 – 9 – 1 – PWR – TV – PWR – TV –
PWR ...
Each time you press the TV key, the remote
control advances to the next manufacturer’s
code in the library.
5. When your device responds by turning off (or
on, if it was off), immediately press SET UP to
lock in the manufacturer’s code.
Note: Because of the large number of codes in
the 6 in 1 IR/RF Remote Control’s library, this pro-
cedure can take several minutes. If your device
turns off during the search, but does not operate
after you lock in the code, begin the search again,
pausing longer between key presses.
15-1925.fm Page 20 Monday, July 19, 1999 12:59 PM