Radio Shack 15-1925 - Manual (Page 24)

Need help? Call 1-800-950-7044
24
Notes:
• You must hold the earpiece of your tele-
phone over the receiver of your remote
control as shown above. If you do not, the
6 in 1 IR/RF Remote Control might not be
able to properly receive the information
coming through the telephone.
• While the 6 in 1 IR/RF Remote Control is
receiving information, the red light blinks
occasionally to confirm the information
transfer.
• When the 6 in 1 IR/RF Remote Control
has successfully received the information
for your infrared devices and downloading
is completed, the red light blinks twice.
6. Press SETUP again after the red light blinks
twice. The light blinks twice again.
Fast Search
If you have downloaded more than one device
code, the remote control has a Fast Search fea-
ture that allows you to quickly search all loaded
device codes, one at a time, until you find the right
one.
As soon as the upgrade operation is complete,
the 6 in 1 IR/RF Remote Control is ready for you
to fast search the downloaded codes. For exam-
ple, to search the codes downloaded into the re-
mote control’s TV memory:
1. Turn on your TV. Point the remote control at
your TV and press TV then PWR . The remote
control sends the power signal for the first
TV code loaded.
2. If your TV does not turn off, press 1. Your
remote control sends the power signal for
the second TV code loaded.
15-1925.fm Page 24 Monday, July 19, 1999 12:59 PM