Radio Shack 15-1925 - Manual (Page 8)

Need help? Call 1-800-950-7044
8
SETTING UP THE 6 IN 1’S RF
COMMAND CONSOLE
After you install batteries in the 6 in 1, just plug the
RF command console’s power cord into any stan-
dard AC outlet in the same room as your IR re-
mote-controlled devices (TV, VCR, cable box,
and so on) and fully extended its antenna. Be
sure the command console is pointed at the de-
vices you want to control.
The command console has a 4-foot IR signal ex-
tension cord for use with devices that are not in
the command console’s line of sight. If you have
such a component, plug the extension cord into
the back of the command console and use the
supplied double-sided tape to attach the exten-
sion cord’s LED over or next to the device’s IR
sensor.
Note: The 6 in 1 transmits both IR and RF signals
at the same time. When testing the command
console, be sure the 6 in 1 is not pointed at your
devices.
LIGHTING THE KEYS
Press to light the keys on the remote. Now,
every time you press a key, the 6 in 1 lights up
and stays lit for about 5 seconds.
To turn off the light, press again.
15-1925.fm Page 8 Monday, July 19, 1999 12:59 PM