Radio Shack 15-1925 - Manual (Page 21)

Need help? Call 1-800-950-7044
21
If necessary, repeat these steps for each device.
Determining the 3-Digit Code
After you set up your 6 in 1 IR/RF Remote Control
using the manual code search, you can find which
3-digit code the 6 in 1 IR/RF Remote Control is
set to by following these steps.
1. Press the device key you want to get the
manufacturer’s code from.
2. Hold down SET UP until the red light blinks
twice, then release it.
3. Press 9 – 9 – 0 . The red light again blinks
twice.
4. Press 1 , and count the number of times the
red light blinks. This is the first number of
your 3-digit manufacturer’s code.
Note: If the red light does not blink, the digit
is a zero.
5. Press 2 and count the number of times the
red light blinks. This is the second number of
your 3-digit manufacturer’s code.
Note: The red light does not blink if the sec-
ond digit of your 3-digit manufacturer’s code
is a zero.
6. Press 3 and count the number of times the
red light blinks. This is the third digit of your
3-digit manufacturer’s code.
Note: The red indicator does not blink if the
third digit of your 3-digit manufacturer’s code
is a zero.
15-1925.fm Page 21 Monday, July 19, 1999 12:59 PM