Radio Shack HANDHELD TRUNKING 20-521 - Manual (Page 29)

29
When the scanner stops on a transmission, quickly
press either:
• HOLD to stop searching so you can listen to the
transmission. HOLD appears.
• MON/CLEAR to store the displayed frequency into
the current monitor memory.
To release hold and continue searching, press
HOLD or hold down t or s for at least 1 second. Or,
if you did not press HOLD , simply press t or s to
continue searching.
Note: Because there are many different frequencies al-
located to fire and police departments, it takes several
minutes to search all these frequencies.
Search Skip Memory
You can skip up to 20 specified frequencies during a
limit or direct search and up to 20 specified frequencies
during a service bank search. This lets you avoid un-
wanted frequencies or ones you have already stored in
a channel.
To skip a frequency, press
S/S when the scanner
stops on the frequency dur-
ing a limit, direct, or service
search. The scanner stores
the frequency in memory
and automatically re-
sumes the search.
To clear a single frequency from skip memory so the
scanner once again stops on it during a limit, direct, or
service bank search:
1. Press HOLD to hold the search.
2. Press t or s to select the frequency. L/O ap-pears.
3. Press S/S . L/O disappears.
To clear all the skip frequencies at once while search-
ing, press
HOLD , then hold down S/S until the scanner
beeps twice (about 3 seconds).