Radio Shack HANDHELD TRUNKING 20-521 - Manual (Page 51)

51
4. Press again.
5. Repeatedly press s or t to select the name of the
map you want (such as E1P7 ). The prepro-
grammed fleet map appears.
6. Press E , then SRC. The scanner then searches for
transmissions using the preset map you chose.
Note: When the scanner searches for transmissions,
you see Type I fleet and subfleet IDs such as
100-12 ,
100-9 , 000-12 , or 400-8 .
How do you know if the preset map you selected is cor-
rect? Listen to see if you are following complete conver-
sations. If not, try another preset map.
Programming a Fleet Map
1. Set the scanner for conventional scanning, press
PROG , then press TRUNK .
2. Select the bank where you want to program the
fleet map by pressing a number key.
3. Press .
4. Repeatedly press s or t to select E1 , then press
. A preprogrammed fleet map appears.
5. Repeatedly press s or t until USr appears. Then
press E .
6. Press .
7. Repeatedly press s or t to select the size code for
the first block, then press E . The next available
block appears.
8. Repeat Step 7 until you have selected a size code
for each block you want to work with.
DATA
DATA
DATA
DATA
Block