Radio Shack HANDHELD TRUNKING 20-521 - Manual (Page 42)

42
Before scanning a trunked system’s transmissions, you
must store the trunked system’s frequencies in one of
the banks in your scanner by following these steps.
1. Press PROG then TRUNK . TRUNK appears and
one or more bank numbers flash.
2. Select the bank you want to store the trunked sys-
tem’s frequencies in by pressing a number key.
The scanner automatically selects the first channel
in the bank when you select the bank.
3. Use the number keys to enter one of the trunked
system’s frequencies, then press E . TRUNK,
BANK and the bank number, the channel number,
and the frequency appear.
Note: If you entered an invalid frequency, the
scanner beeps, the channel number flashes and
Error appears. If this happens, press • to clear
the frequency, then repeat this step.
4. Press either PROG or s to select the next channel
in the bank.
5. Repeat Steps 3 and 4 until all frequencies have
been entered in that bank.