Radio Shack Dual Keypad - Manual (Page 10)

10 Installation
5. Route the adapter’s cord through the
strain relief slot on the bottom of the
bracket.
6. Plug the adapter into a standard AC out-
let.
7. Lift the base’s antenna to a vertical posi-
tion.
On a Wall Plate or Wall
1. Insert the bracket’s tabs into the base’s
lower tab slots, then press down on the
bracket’s clips and insert them into the
clip slots.
2. Plug one end of the supplied short mod-
ular cord into the TEL LINE jack on the
back of the base.
3. Insert the supplied AC adapter’s barrel
plug into the DC IN 9V jack.
4. Route the adapter cord through the
groove on the bracket.
5. Plug the modular cord’s other end into
the wall plate jack, then align the
bracket’s keyhole slots with the wall
plate studs and slide the phone down-
ward to secure it.
6. Plug the adapter into a standard AC out-
let.
7. Lift the base’s antenna to a vertical posi-
tion.
Note: To mount the phone directly on a wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on the
bottom of the base.
Follow the steps under “On a Wall Plate or
Wall,” then apply these additional instruc-
tions.
1. Drill two holes 3 15 / 16 inches (100 mm)
apart. Then thread a screw into each
hole, letting the heads extend about
1 /
8
inch (3 mm) from the wall.
2. Plug one end of the supplied long modu-
lar cord into the TEL LINE jack on the
back of the base and route the adapter
cable and modular cords through the
grooves on the bracket.
3. Align the bracket’s keyhole slots with the
mounting screws and slide the phone
downward to secure it.