Radio Shack Dual Keypad - Manual (Page 13)

13 Installation
the handset also rings (unless you set the
handset’s ringer to off).
TURNING AUTO TALK ON/
OFF
Your phone is preset so you must press
TALK when you lift the handset from the base
to answer a call. With auto talk turned on,
you can answer a call by just lifting the hand-
set from the base. If the handset is away
from the base, you can answer by pressing
any key.
Follow these steps to turn auto talk on or off.
1. Lift the handset and press MENU . A
menu appears with
7kje 7kje 7kje 7kje JWba JWba JWba JWba
selected.
2. Press SELECT/INTCM to change the auto
talk setting.
Ed Ed Ed Ed
or
E\\ E\\ E\\ E\\
appears indicating
the selected setting.
3. Return the handset to the base or press
MENU to store the new setting.
TURNING CALLER ID/CALL
WAITING ON/OFF
If you subscribe to Call Waiting with Caller ID
service, you can set the phone to show Call-
er ID information for an incoming call even
while you are using the phone.
Follow these steps to turn the Caller ID/Call
Waiting feature on or off.
1. Lift the handset and press MENU . A
menu appears with
7kje 7kje 7kje 7kje JWba JWba JWba JWba
selected.
2. Press 2 or VOL/CID
9 9 9 9
to select
9?:9M 9?:9M 9?:9M 9?:9M
(Caller ID/Call Waiting).
3. Press SELECT/INTCM to change the
Caller ID/Call Waiting setting.
Ed Ed Ed Ed
,
E\\ E\\ E\\ E\\
, or
Efj Efj Efj Efj
appears.
4. Press MENU then return the handset to
the base to store the new setting.
With the Opt setting, you can use the ad-
vanced Caller ID/Call Waiting options. See
“Call Waiting Options Service” on Page 21.
STORING YOUR AREA
CODE
You can store your local area code in the
phone’s Caller ID record so it does not show
the area code if the received call is from your
local area. If for some reason you need to
dial the area code (or store in the memory),
you can add it afterwards. See “Adding/De-
leting the Area Code” on Page 23.
Note: If your calling area requires 10-digit di-
aling including area code, do not enter the
area code but leave this option blank.
Follow these steps to store your area code.
1. Lift the handset and press MENU .
2. Press 3 or VOL/CID
9 9 9 9
twice to select
7h[W 7h[W 7h[W 7h[W 9eZ[ 9eZ[ 9eZ[ 9eZ[
.
3. Press SELECT/INTCM , then enter your
three-digit area code. If you make a mis-
take, repeatedly press
6 6 6 6
REDIAL or
FLASH
7 7 7 7
to move the cursor over the
incorrect digit, then enter the correct
number.
Note: If an area code is already stored,
it appears on the display. To delete the
area code, press
DELETE/CH three
times. Then enter your area code. Or
you can use
6 6 6 6
REDIAL or FLASH
7 7 7 7
to
move the cursor and edit the area code.
4. Press SELECT/INTCM to store the area
code, then press MENU or return the
handset to the base to clear the display.