E-35 – Olympus PT-027 User Manual

Page 36

Advertising
background image

E-35

Clean and apply O-ring
silicon grease to these
sections.

Maintenance of the threaded sections on the
TTL cable and TTL cable connector

If the threaded sections used to connect the TTL cable to the TTL cable
connector are not maintained properly, salt and other seawater residue
may adhere the TTL cable and prevent it from being disconnected.
After use in seawater, clean off any salt, sand, or other residue as soon
as possible, then dry the equipment thoroughly. Clean the threaded
sections with a cotton swab and apply a thin, uniform layer of O-ring
silicon grease (provided with this case).

Maintenance of the TTL Connector Cap

After removing the TTL connector cap from the waterproof cap, be sure
to clean and grease the O-ring.
Use the waterproof cap maintenance adapter to remove the O-ring unit
from the waterproof cap.

Waterproof cap

Waterproof cap
maintenance adapter

O-ring

Insert the adapter by aligning its pin with the
hole on the cap.

Turn the adapter counterclockwise to remove
the O-ring unit.

After removing the O-ring attached to the O-
ring unit, clean the O-ring groove and apply
silicon grease to the O-ring. Then, re-attach
the O-ring to the O-ring unit.

❈ Reverse the removal procedure to re-attach the O-ring unit to the

waterproof cap.

1

2

3

Advertising