Omega Vehicle Security Wireless Sensor System zSeries - Manual (Page 12)

2.1b Parts of the End Device (zED-CCELL)
1 8 position DIP switch (under cover), sets the NID and DID of the End Device
(see Section 2.7 for details)
2 Power Switch (under cover)
3 Label for Unit Address, Group No. and Network ID Address (NID)
4 Wall mounting holes
5 Label with model and serial numbers
6 Radio module firmware revision location on label
7 Case’s tray, where the PCB, sensor and batteries are mounted
8 Case’s cover
9 Transmit LED (blue)
10 Four (4) Screws attaching Cover
11 Two (2) C-cell batteries (under cover)
12 External probe/sensor, through cable gland (for zED-TC-x) or quick
disconnect connector
. Refer to Figure 2.2a for connector configurations.
13 Antenna Mount
14 Thermocouple (if ordered) removable terminal block connector (under cover)
Figure 2.1b Parts of the End Device (zED-CCELL)
SENSOR
INPUT
MODEL #
SERIAL #
#.#
5
6
8
7
2
9
10
11
14
Unit Addr Group Net. Addr
FRONT REAR
1
3
4
13
12
6
Warning:
the following parts are
ESD sensitive.