Omega Vehicle Security Wireless Sensor System zSeries User Manual
Page 22
Advertising
16
2.4d Disassembly - End Device (zED-DC-H2)
You may need to open the unit for one of the following reasons:
•
To turn on Power Switch.
•
To access 8 Position DIP Switch.
•
To mount unit to wall. Refer to Figure 2.2b for mounting dimensions.
•
To access Thermocouple Input Terminal Block Connector.
•
To access Low Power Input Terminal Block Connector.
•
To access programming connector.
Open Cover as shown below, by removing the Cover Mounting Screw.
Figure 2.3d Disassembly of the End Device (zED-DC-H2)
Advertising