Omega Vehicle Security Wireless Sensor System zSeries User Manual
Page 23
2.4e Disassembly - End Device (zED-x-LCD-AA-H or zED-x-CCELL-H)
You may need to open the unit for one of the following reasons:
•
To turn on Power Switch.
•
To mount unit to wall. Refer to Figure 2.2a for mounting dimensions.
•
To connect or replace the alkaline batteries, (note the polarity of battery).
•
To access programming connector.
Remove Cover as shown below, by removing the 4 Cover Mounting Screws.
Figure 2.4e Disassembly of the End Device (zED-x-LCD-AA-H or zED-x-CCELL-H)
TRAY
COVER
MOUNTING
SCREWS (4)
COVER
8
1
DIP SWITCH
AA ALKALINE
BATTERIES
TRAY MOUNTING
ANTENNA MOUNT
1
1
EXTERNAL SENSOR /
PROBE INPUT
QUICK DISCONNECT
CONNECTOR
BATTERY CLIPS
PROGRAMMING/
LCD CABLE CONNECTOR
LCD CABLE
POWER
SWITCH
POWER SWITCH
BATTERY CLIPS
PROGRAMMING
CONNECTOR
DIP SWITCH
C-CELL
BATTERIES
EXTERNAL SENSOR /
PROBE INPUT
QUICK DISCONNECT
CONNECTOR
zED-THP2-LCD-AA-H
zED-THP2-CCELL-H
17