Omega Vehicle Security Wireless Sensor System zSeries User Manual
Page 13
7
2.1c Parts of the End Device (zED-CCELL-H/zED-LCD-AA-H)
1
8 position DIP switch (under cover), sets the NID and DID of the End Device
(see Section 2.7 for details)
2
Power Switch (under cover)
3
Label for Unit Address, Group No. and Network ID Address (NID)
4
Wall mounting holes
5
Label with model and serial numbers
6
Radio module firmware revision location on label
7
Case’s tray, where the PCB, sensor and batteries are mounted
8
Case’s cover
9
Transmit LED (blue)
10
Four (4) Screws attaching Cover
11
Two (2) AA alkaline or (2) C-cell alkaline batteries (under cover)
12
External probe/sensor, through quick disconnect connector
.
Refer to Figure 2.2a for connector configurations.
13
Antenna Mount
14
LCD Display (if ordered)
Figure 2.1c Parts of the End Device (zED-CCELL-H/zED-LCD-AA-H)
MODEL #
SERIAL #
#.#
2
9
10
3
6
5
Unit Addr Group Net. Addr
FRONT
REAR
1
13
12
+
-
11
4
7
8
for -AA
for -CCELL
zED-x-CCELL-H
zED-x-CCELL-H
2
9
10
14
FRONT
1
13
12
+
+
-
-
11
8