Omega Vehicle Security Wireless Sensor System zSeries - Manual (Page 24)

18
2.4f Disassembly - End Device (zED)
You may need to open the unit for one of the following reasons:
• To turn on Power Switch.
• To mount unit to wall. Refer to Figure 2.2b for mounting dimensions.
• To connect or replace the two 1.5 Vdc AA alkaline batteries, (note the polarity of
batteries).
• To access programming connector.
Remove Cover as shown below, by pressing sides of cover to release latches.
Figure 2.4f Disassembly of the End Device (zED)
COVER
LATCH
SENSOR
BOARD
EXTERNAL
SENSOR/
PROBE
TRAY
POWER SWITCH BATTERY CLIPS
LATCH
DIP SWITCH
MOUNTING SCREW
PROGRAMMING
CONNECTOR
8
1
AA ALKALINE
BATTERIES