Oki 5950 - Manual (Page 146)

|
OKIFAX 5750/5950 136
Problem Solving
No communication
1
Verify that the “#” symbol was the first character entered
when sending the facsimile.
2 Verify that the Address Table in the IPFax Console
Software is correctly programmed.
3 Are any of the following service codes shown on the
display panel of the facsimile machine?
1501: Remote facsimile machine rejection
1502: GK rejection
1503: No response
1504: Cancel
1505: Board BUSY
1506: Phone number error
1507: GK not found
1508: DHCP failure
15FE: Board error
15FF: Board error
4 Does the port number used in IPFAX communication
match the IPFAX of the remote machine?
5 Is the remote device T.38 compliant?
6 Is the connected network 10 BaseT?
This facsimile machine does not support 100 BaseT.