Optimus PROFFESIONAL SERIES STAV-3370 - Manual (Page 12)

12
Preparing Your Receiver
Using One Remote Control
for More than One Unit If you also have an Optimus professional series CD player, VCR, or cassette
deck with the OSR mark, you can connect its
CONTROL IN jack to the receiver
so you can control all of your equipment with a single remote control. You can
also use the other component’s remote control by pointing it at the receiver’s
front panel.
1. Connect each component to the receiver as shown in “Connecting Pro-
gram Sources.”
2. Connect the cable supplied with the CD player, VCR, or cassette deck
between the receiver’s CONTROL OUT jack and the other component’s
CONTROL IN jack.
3. When you want to control more than one other component using the
receiver’s remote control, daisy-chain the CONTROL OUT and CONTROL
IN connections as shown.
Installing the
Remote Control’s Batteries The remote control uses two AA batteries (not included). For the longest battery
life, we recommend Radio Shack’s alkaline batteries (Cat. No. 23-557).
1. Press and open the battery
compartment cover.
2. Place two fresh AA batteries in
the compartment as indicated by
the polarity symbols (+ and –)
marked in the compartment.
3. Replace the battery compartment
cover.
Note: When you plug the cable into a
component’s
CONTROL IN jack, that
component’s remote sensor does not
function.
Cautions:
• Use only fresh batteries of the recom-
mended size and type.
• Always remove old or weak batteries.
Batteries can leak chemicals that can
damage electronic circuits.
Note: If the remote’s range is reduced,
replace the batteries immediately.
OUT
IN
CONTROL
OUT
IN
CONTROL
Receiver
Remote
Control
Other Component
with OSR Mark
To the CONTROL IN jack
of Another Component
Having the OSR mark