Optimus PROFFESIONAL SERIES STAV-3370 - Manual (Page 22)

22
Using the Remote Control
The remote control works up to a distance of about 23 feet, and within a 30-
degree angle on either side of the receiver. Point the control at the receiver’s
front panel and press the desired button(s).
Many buttons on the remote control work the same as buttons on the receiver’s
front panel. Use these buttons exactly as you would use the corresponding but-
tons on the receiver.
AUDIO
/
VCR Switch
The remote control can also control other compatible audio/video components
when you connect them to the receiver’s
CONTROL OUT jack. Set the switch to
AUDIO to control audio components such as CD players or cassette decks. Set
the switch to VCR to control video components such as a VCR.
When you set the switch to VCR , dual-function buttons control the function
marked in gold next to the button. For example, the button marked CENTER
MODE and TEST TONE operates as the center mode adjust when you set the
switch to AUDIO and as the delay time function when you set the switch to VCR .
Receiver/Amplifier Section
FUNCTION Selects a program source (VCR/Tape 1, LD, CD, tuner, or
phono). Repeatedly press FUNCTION until the display shows
your desired program source. See Page 14.
– MASTER VOLUME + Adjusts the system’s volume. See Page 14.
CENTER MODE Selects among the three center mode settings with AUDIO
/
VCR set to AUDIO. See Page 21.
– CENTER + Controls the relative volume of the center speaker with
AUDIO
/
VCR set to AUDIO. See Page 21.
– REAR + Controls the relative volume of the rear speakers with
AUDIO
/
VCR set to VCR. See Page 21.
TEST TONE Sounds test tones from each speaker with AUDIO / VCR set to
VCR. See Page 21.
DELAY TIME Sets the rear-channel delay for Dolby Pro-Logic Surround
and Simulated Surround programs with AUDIO
/
VCR set to
VCR. See Page 21.
SURR MODE Selects between Dolby Pro-Logic Surround or Simulated Sur-
round sound. See Page 20.
SLEEP Sets the receiver to turn off after 90, 60, or 30 minutes with
AUDIO
/
VCR set to AUDIO. To start the timer, repeatedly
press SLEEP until the desired turn-off time ( 90 , 60 , or 30 )
appears. To cancel the timer, repeatedly press SLEEP until
the sleep time disappears from the display. See Page 17.
RECEIVER POWER Turns the receiver on and off. See Page 14.
RETURN Returns the receiver to its default settings. See Page 27.
3CH LOGIC Selects Dolby 3CH Logic. See Page 20.
TAPE 2 MONITOR Switches the receiver to monitor the source connected to the
TAPE 2 MONITOR jacks. See Page 18.