Optimus PROFFESIONAL SERIES STAV-3370 - Manual (Page 6)

6
Preparing Your Receiver
Connecting Speakers Preparing the Speaker Wires
Speaker wire consists of two conductors (individual wires) encased in insulation
and is usually color-coded or marked with a ridge along one side so you can
identify each conductor. Use these markings as a guide to help you properly
connect the speakers to your receiver.
Follow these steps to prepare the speaker wires.
1. Cut the speaker wires to the necessary length.
2. Separate the wires about 4 inches on each end.
3. Using a wire stripper, carefully strip about 3 / 4 inch of insulation from the
end of each conductor.
4. Twist the end of each conductor to secure any loose wire strands.
Follow these guidelines when you select
and connect speakers.
• Be sure you properly connect all
speakers.
• Do not connect two pairs of speakers
to a single set of terminals (A or B) at
the same time. When you use two
pairs of speakers, connect one set to
Speakers A and one set to Speakers B .
• Realistic, Optimus, and other high-
quality speakers have color-coded
speaker terminals (red for positive
polarity and black for negative polar-
ity). Use these color-coded terminals
as a guide to help you properly con-
nect the speakers to the receiver.
• Use 16-gauge (or larger) speaker wire
for all speaker connections, and con-
sider possible speaker locations
before you decide how much speaker
wire you need.
A
B
A
B
R R L
R L
L
CENTER
SPEAKER
REAR
SPEAKERS FRONT SPEAKERS
Left Surround
Speakers
Center Speaker
Left Front B Speaker
Left Front A Speaker