Oregon Scientific PE830 - Manual (Page 7)

6
EN
CALORIE
TARGET
To set step, distance or calorie target:
1. Press MODE to
navigate to Target
Mode.
2. Press and hold SET
for 2 seconds to enter
setting mode.
3. Press / to select STEP, DISTANCE or
CALORIES.
4. Press SET to confirm.
5. Press / to change the value of each digit, and
SET to confirm and move on to the next setting.
To use target:
1. Once the target has
been set, start walking
to activate the
pedometer. The GO!
screen will appear to
confirm that the unit is
starting to monitor
your progress.
2. While you are walking, the ESTIMATED FINISH TIME
(EFT) will periodically appear to advise you how long
it will take to complete your target, based on your
current pace. The target bar at the bottom of the
display will move from left to right (start to finish) to
show your progress.
3. Press to toggle between the EFT and remaining
steps, distance or calories left until target is reached.
4. When target walk is
complete, FINISH will
appear and a beep will
sound.
5. To reset the target for the next user session, press
and hold RESET.
TIMER
When the timer is running, it will measure steps, distance
and calories. These measurements are not linked to the
daily measurements and are only related to the time spent
walking while the timer is on.
PE830_EU_M_EN_R1.p65 2006.8.16, 4:47 PM 6