Olympus C-40Zoom - Manual (Page 187)

187
Chapter 12
Troubleshooting (Cont.)
POSSIBLE CAUSES CORRECTIVE ACTION REF. PAGE
The flash does not fire.
1 The flash is set to the
off mode.
2 The subject is lighted.
3 Sequential shooting is
on.
4 You are recording
movies.
5 Panorama shooting is
performed.
6 FUNCTION is set to
BLACK/WHITE BOARD.
1 Press the button to select
a flash mode other than .
2 Set the flash to Fill-In mode.
3 Set DRIVE to
in the
menus.
4 Set the mode dial to any
position other than .
5 Set PANORAMA to OFF in
the menus.
6 Set FUNCTION to OFF in
the menus.
P. 87
P. 84
P. 96
P. 61
P. 101
P. 103
Pictures you have already taken do not appear on the monitor.
1 The camera is in the
shooting mode.
2 There is no picture in
the card.
3 There is a problem with
the card.
4 The camera is
connected to a TV.
1 Close the lens barrier and
press the button.
2 NO PICTURE appears on the
monitor. Record pictures.
3 See the error code chart.
4 The monitor does not
function when the camera is
connected to a TV.
P. 119
P. 38, 39,
194
P. 194
P. 137
1 The brightness is not
adjusted properly.
2 The monitor is exposed
to direct sunlight.
1 Adjust the brightness.
2 Block the sunlight.
P. 79
The monitor is not clear.