Olympus C-40Zoom - Manual (Page 81)

81
Chapter 4
4 Press the shutter button all the way to stop
recording.
● The card access lamp blinks and the camera
begins storing the movie on the card. You cannot
record another movie as long as the card access
lamp is blinking.
● When the card access lamp stops blinking, the
camera has finished writing the movie to the
card. If there is any space left on the card, the
number of seconds remaining is displayed. You
can start shooting another movie.
● When you the remaining time displayed has been used up, shooting
stops automatically and the camera starts writing the movie to the card.
This will happen regardless of whether or not you press the shutter
button to stop shooting.
If you take pictures continuously, the indication
changes as shown below.
Recording movies (Cont.)
● Shooting is not possible.
T Shooting is not possible while the camera is saving pictures to the
card. If the memory gauge goes off, you can take another shot.
T If CARD FULL appears, there is no space left on the card. Delete
pictures (P. 134, 135), replace with a new card (P. 29) or transfer
pictures to a computer (P. 175 – 178, 181).
TIPS
Before
shooting
After shooting, these indications may still be on the
screen. Shooting is not possible until they are gone.
During shooting Shooting
finishes
automatically.
Card access lamp
OK