Olympus CAMEDIA P-200 - Manual (Page 34)

Setting up the printer
Connecting the power supply
To supply power from the provided AC adapter
1. Plug the printer power cord into the AC adapter.
2. Plug the AC adapter power cord into a wall outlet,
then plug the other end of the printer power cord
into the printer's DC power input connector.
3. Press and hold the POWER button for more than 1.5
seconds.
4. The printer turns ON with a beep tone, and the
control panel is displayed.
5. To turn the printer OFF, press and hold the POWER
button for more than 1.5 seconds. The control panel
will turn off and the printer turns OFF with a short
beep.
If you want to use the AC adapter as the power
supply to the printer, remove the rechargeable
battery if possible. This will help prevent deteriora-
tion of the rechargeable battery.
If the printer power cord is accidentally unplugged
from the printer during printing, turn the printer
OFF, plug the printer power cord into the printer's
DC power input connector, and then turn the printer
ON again. Leaving the printer unplugged in printing
mode may cause it to malfunction.
Setup
Setup 15