Olympus CAMEDIA P-200 - Manual (Page 35)

Notes
• Recharging time varies
depending on the
remaining battery power
and environmental
conditions.
• Even when the battery is
installed, it is not
recharged while the
printer is set to ON.
Recharging only takes
place when the printer is
OFF.
• Once you started
recharging, it is
recommended that you
fully recharge the battery
without interruption. (Do
not turn the printer ON
or OFF during
recharging.)
• When a fully discharged
battery is recharged, a
pre-charging period of
up to 1 minute takes
place before the
ACCESS/CHARGE
indicator lights up. (The
indicator does not light
in the pre-charging
period.)
To supply power from the optional rechargeable
battery
1. Installing the battery
1) Turn the printer OFF and unplug the AC adapter
power cord.
2) Remove the rear cover.
3) Position the battery so that the marking on the
battery points in the same direction as the one on the
printer. Align the battery with the printer as shown in
illustration 3), then push the entire battery toward the
printer.
4) While pushing the battery against the printer, slide the
battery toward the battery unlock lever until it clicks.
2. Recharging the battery
1) Connect the AC adapter.
2) The ACCESS/CHARGE indicator lights to indicate
that recharging has started.
3) Recharging takes about 2.5 hours. The ACCESS/
CHARGE indicator turns off when recharging is
complete.
3. Battery power operation
1) Disconnect the AC adapter from the printer and turn
the printer ON.
When the AC adapter is connected, the printer is
always powered by the AC adapter.
The control panel shows the remaining battery power.
Setup 16