Olympus CAMEDIA P-200 - Manual (Page 47)

Note
• If your digital camera
does not assign file
names using 7 digits, use
the frame number
display function (with
the FRAME indicator lit).
The corresponding frame
numbers can be checked
by performing index
printing (see page 33).
Caution
• When the button
function is switched to
the frame number
display function after
selecting more than one
print copy, the COPIES
indicator on the control
panel blinks to indicate
that the number of print
copies selected is more
than one.
Use the following procedure to change the
display to show the higher 3 digits of the file
name (the higher 3 digits of the file name are
the one that is displayed on the LCD screen of
the digital camera).
Press the (+) and (-) buttons simultaneously for about 2 seconds.
• The FILE NAME indicator blinks and the higher 4 digits are
displayed.
Press the (+) or (-) button while FILE NAME blinks to display
higher 3 digits of other files.
• When no button is pressed for 3 seconds or more, the lower 4
digits for the newly selected higher 3 digits will be displayed.
• To display the higher 3 digits again, restart the procedure
from step again.
Press the NUMBER button to switch the button
function to the number of print copies selection
function.
Select the desired number of print copies with the (+)
or (-) button. Any number between 1 and 25 can be
selected.
The default print copies setting is 1. The above
operation is required only when you want to print
more than one copy of the same image.
<FRAME>
<Number of print copies
with upper limit at 25>
Basic Printing
<COPIES>
2
28