OxiBrands Integrated High Definition LCD Television 40E220U - Manual (Page 104)

104 Using the TV’s features
Displaying TV status information
When you turn on the Audio Receiver, change its input source or
adjust the sound volume, the sound will be output from the audio
receiver’s speakers even if TV Speakers has been selected. Turn the
TV off and on again to output the sound from the TV speakers.
Setting up REGZA-LINK ®
To access the REGZA-LINK ® Setup:
1 From the Setup menu, highlight REGZA-LINK Setup and
press the ENTER button.
2 Press the ( / arrow) buttons to highlight Enable
REGZA-LINK.
3 Press the ( / arrow) buttons to select On.
If you select Enable REGZA-LINK ® Off, the other items will be grayed
out.
4 Press the ( / arrow) buttons to highlight the REGZA-LINK
Setup item you want to use, and press the ( / arrow) buttons
to select On or the desired mode.
❖
TV Auto Input Switch: On/Off
❖
TV Auto Power: On/Off
❖
Device Auto Standby: On/Off
❖
Speaker Preference: TV Speakers/Audio Receiver
5 To save the new settings, highlight Done and press the ENTER
button.
To revert to the factory defaults, highlight Reset and press the
ENTER button.
Displaying TV status information
To display TV status information using the RECALL button:
❖
Press the RECALL button on the remote control.
The following information will be displayed (if applicable):
❖
Current input (ANT/CABLE, Video, etc.)
❖
If ANT/CABLE is the current input, either “CABLE” (for
cable TV) or “ANT” (for over-the-air broadcasts).
❖
Channel number (if in ANT/CABLE mode)
NOTE
NOTE