Oki lan 7100e+ - Manual (Page 17)

|
User’s Guide: English 17
Settings
!
Only some of the following settings may be applicable
to your specific network environment.
Network Connection
Protocol Option–Lets you enable/disable each protocol.
Frame Options–Lets you set the frame type of the network.
TCP/IP Settings
DHCP/BOOTP–For the IP address to be dynamically
configured using a DHCP/BOOTP server, set to
[ENABLE]. To enter the IP address manually, set to
[DISABLE].
RARP–For the IP address to be dynamically configured
using a RARP server, set to [ENABLE]. To enter the IP
address manually, set to [DISABLE].
IP Address, Subnet Mask, Default GateWay–Enter the IP
address, subnet mask and default gateway assigned to the
network print server using the decimal system in the
following format: “***.***.***.***” If you use a DHCP/
BOOTP or RARP Server, these settings may not be
required.
NetWare Settings
Printer Name–name of the fax machine.
NetWare Mode–Sets the network print server operating
mode to print server mode (PSERVER) or remote printer
mode (RPRINTER).
Print Server Mode
NetWare Print Server Name–Enter the print server name
stored on the file server in print server mode. Make sure
this name matches the “Print Server Name” stored on the
file server. Maximum length: 31 characters.
Password–This is a password to log in to the file server in
print server mode. Make sure this password is identical to
that configured on the file server. Maximum length: 31
characters.
Job Polling Rate–Set the interval for polling the print queue
in print server mode. The smaller the value, the greater the
load on the network. The larger the value, the worse the
printing response. The default value should normally be
used. The setting may be between 2 –255 seconds.
Maximum Number of File Servers–Enter the number of file
servers on the network.
Bindery Mode–In print server mode, if printing with NW4.1
bindery service or NW3.1, always set the bindery mode to
[ENABLE]. If printing only with NW4.1 NDS service, set
the bindery mode to [Disable].