Oki lan 7100e+ - Manual (Page 18)

18 Network print server
|
NDS
Tree Name–In print server mode, enter the name of the tree
in which the file server is located. Maximum length: 31
characters.
Context–In print server mode, enter the name of the context
in which the Print Server was created. Maximum length:
77 characters. For example, LAB.OKI. Field is case
sensitive!
File Servers per Pserver Mode
File Server Name–Enter the name of the file server
controlling the NETWORK PRINT SERVER in print
server mode. A maximum of eight file servers may be
designated. Maximum length: 31 characters.
Remote Printer Mode
Printer Name for R-Printer Mode–Enter the printer name
stored on the print server in remote printer mode. Make
sure that this name is identical to the “Printer Name”
stored on the print server. Maximum length: 31 characters.
Job Timeout–This is the time from receiving the last print
packet to releasing the NETWORK PRINT SERVER port
at the end of the print job, in remote printer mode. If the
set value is too low, any packet delay may stop printing
part way through. The default value should normally be
used. The setting may be between 4 - 255 seconds.
Print Server Name–Enter the print server name controlling
the network print server in remote printer mode. A
maximum of eight print servers may be designated.
Maximum length: 31 characters.
NetBEUI Settings
Computer Name–Enter the name of the computer. Maximum
length: 15 characters.
Workgroup Name–Enter the name of the workgroup.
Maximum length: 15 characters.
Comment–Enter user information relating to the computer.
Maximum length: 48 characters.
EtherTalk Settings
Note: EtherTalk settings are not supported by the fax
machine.
EtherTalk Zone Name–Enter the new zone name if you
change the zone to which your printer belongs.
EtherTalk Printer Name–Enter the new printer name if you
change the printer name used by Chooser. Maximum
length: 31 characters.