Quantum 560UF/L - Manual (Page 11)

CHAPTER 2. INSTALLATION
ACTIVE Professional External Modem User’s Manual
7
8 Smart/Dumb mode - &A
function
(0) smart, (1) dumb
9 Compression control - %C
function
(0) Enables both MNP5 and V.42bis data compression
(1) Disables data compression
(2) Enables MNP5 data compression
(3) Enables V.42bis data compression
A DTE/DCE Flow control - &K
function
(0) Enables RTS/CTS flow control
(1) Disable flow control
(2) Enables XON/XOFF flow control
(3) Enables transparent XON/XOFF flow control
(4) Enables both RTS/CTS and XON/OFF flow control (default
for fax mode)
C Save to NVM memory - &W
function
(0) profile 0, (1) profile 1
Modem Configuration through front panel (also refer to modem
configuration table)
To configure your modem through modem front panel switches, please
follow the procedures below:
1. After the installation as described in section ‘Install your modem’,
2. Set Normal / Config. Switch to PUSH position for configuration mode.
3. Toggle the Menu Switch to the desired Menu (0 to C). The state is
shown on the LED segment.
4. Toggle the Function Switch to the desired Function. The state is
shown on the LED segment.
5. Press the Enable Switch to update the selected features. The character
‘U’ is shown on the LED segment. (The updated features were saved
to NVM memory profile 0 automatically except menu 7).
6. To finish configuration by setting the Normal / Config. Switch to POP
position.