Quantum 560UF/L User Manual

Page 19

Advertising
background image

APPENDIX A. AT COMMANDS

ACTIVE Professional External Modem User’s Manual

15

ATT *

Set tone dial as default

ATVn *

Result code form (message control)

Default : 1

ATV0

Allows short form (numeric) result codes to be sent

ATV1

Allows long form (verbose) result codes to be sent

ATWn *

Negotiation progress reporting

Default : 0

ATW0

Error-correction call progress not reported

ATW1

Error-correction call progress reported

ATW2

Error-correction call progress not reported. CONNECT
XXXX message reports DCE speed.

ATXn *

Extended result codes

Default : 4

ATX0

Modem ignores dial tone and busy signal. Sends CONNECT

message when a connection is established by blind dialling

ATX1

Modem ignores dial tone and busy signal. Sends CONNECT

XXXX message reflecting bit rate when a connection is
established by blind dialling

ATX2

Modem ignores busy signal but waits for dial tone before

dialling. If dial tone is not detected within 5 seconds, the NO
DIAL TONE message is sent. Sends CONNECT XXXX
message reflecting bit rate when a connection is established.

ATX3

Modem ignores dial tone. Sends BUSY message if a busy

signal is detected. Sends CONNECT XXXX message
reflecting bit rate when a connection is established by blind
dialling.

ATX4

If dial tone is not detected within 5 seconds, sends NO DIAL

TONE message. If busy signal is detected, sends BUSY
message. Sends CONNECT XXXX message reflecting bit
rate when a connection is established.

ATYn *

Control long space disconnect

Default : 0

ATY0

Disables long space disconnect

ATY1

Enables long space disconnect

ATZn

Reset

Default : 0

Restore the active configuration with the user profile
ATZ0

Soft reset and restore stored profile 0

ATZ1

Soft reset and restore stored profile 1

AT&An * Handshake Abort Option

Default : 1

AT&A0

Disables the user abort during handshaking. Once the
dialling string is entered or answer is initiated, the
handshaking cannot be aborted. Only dropping DTR signal
(except &D0 option) and pressing T/D switch can abort the
operation.

AT&A1

Enables the user abort during handshaking. Anytime during

Advertising
This manual is related to the following products: