Quantum 560UF/L - Manual (Page 9)

CHAPTER 2. INSTALLATION
ACTIVE Professional External Modem User’s Manual
5
a. If the modem is in Normal mode, it acts as a O/A switch. Toggle this
switch causes the modem to change from Originate mode to Answer
mode and the LED segment displays ‘A.’ for answer mode, or ’O.‘ for
Originate mode.
b. If the modem is in Config. mode, it acts as an Enable switch. Toggle
this switch causes the modem to execute the selected features and LED
segment shows 'U'. The features (except menu 7) were saved to NVM
profile 0 automatically (please refer to the section ‘modem
configuration').
5. Reset switch
– Press to reset the modem during unexpected software hung-up.
Use T/D Switch to dial
1. Store a 36-digit dial string in the specified entry (n =1-3) for later
dialing (AT&Zn=<T or P><tel. no> , n=1-3, i.e AT&Z1=T123456 for
tone dial, AT&Z1=P123456 for pulse dial).
2. Set Normal / Config. Switch to PUSH position for configuration mode.
3. Toggle the Menu Switch to the desired Menu 7.
4. Toggle the FunctionSwitch to the desired Function (n=1-3).
5. Press the En Switch to execute the selected features. The character ‘U’
is shown on the LED segment.
6. Set Normal / Config. Switch to POP position.
7. Press the T/D Switch to dial the specific entry (Dial number previously
stored in directory location n using AT&Zn).