QMS Scanner - Manual (Page 30)

4-14
AUTOMATIC POWER SAVING
QMS SC-100 features automatic power saving without
unplugging the power cable. If you have not used QMS
SC-100 over an hour, the QMS SC-100 automatically
turns into power saving status to save the power. At this
moment, the Message window displays “Power Saving…”
while the Ready LED is flashing.
To resume the ready status, press any one of the button on
the Control Panel. The Message window displays
“Warming up…” and then “1 Copy @100%”, the ready
status. The Ready LED now turns steadily on.
* * Tips:
•
About the “Select” button: The major function of
the “Select” button is to select the printer model.
However, as long as your printer model has PCL
emulation, it is not required to select the printer model - to
touch the “Select” button.
•
About the default settings: The default settings can
be easily recognized by the ending “*” mark when the
setting is displayed in the Message display window. It is
OK yet not recommended if you want to change the default
setting. To change the factory default setting, simply press
the “Select” button after your desired setting is shown in
the Message display window. After one minute, the setting
will be automatically reverted to the factory default setting.