Quantum 600 XL - Manual (Page 25)

Quantum 600 XL www.quantumrehab.com 25
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the armrest
receiver bracket. See figure 17.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 17.
2. Loosen the locking nut.
3. Turn the adjusting screw clockwise to raise the front of
the armrest, or turn the adjusting screw anticlockwise
to lower the front of the armrest.
4. Tighten the locking nut to lock the adjusting screw into
place.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the two setscrews located on the armrest re-
ceiver. See figure 17.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.
V . C O M F O R T A D J U S T M E N T S
Figure 18. Adjusting Controller Position (Synergy Seat)
SETSCREWS
MOUNTING SCREWS
Figure 19. Controller Position - Underside of Armrest
SETSCREW
Controller Position Adjustment
You can position the controller for either left-hand or right-hand use.
WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the
power base frame.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear shroud.
3. Unplug the controller connector(s) from the power base.
4. Remove the wire ties securing the controller cable to the armrest.
5. Loosen the mounting screws in the controller mounting block. See figure 18.
6. Move the controller mounting block and controller to the other armrest and tighten the mounting screws.
NOTE: For contour seats, loosen the setscrew on the underside of both armrests, transfer the controller, and
tighten the setscrews. See figure 19.