Quincy Compressor 50093-103 - Manual (Page 57)

51
4.) Preheat the seal wear sleeve to 350°F in a small oven.
Do not preheat in warm oil. Apply a thin film of
LOCTITE to the inner diameter of the wear sleeve and
immediately install on the compressor shaft using the
proper wear sleeve driver. Drive the wear sleeve on
the shaft until the driver bottoms on the shaft
shoulder.
Seal Installation
1.) Apply a thin coat of compressor fluid to the outer
face of the seal wear sleeve and seal lip.
2.) Cover the keyway in the compressor shaft with
masking tape so there is no chance of damage
occurring to the seal face during installation.
3.) Slide the proper seal installation sleeve against the
wear sleeve with the taper toward the end of the rotor
shaft. Install a new o-ring on seal adapter and
lubricate with compressor fluid. Carefully slide the
seal adapter with the new seal installed over the end
of the rotor shaft and up against the adapter bore.
4.) Using care not to damage the o-ring, evenly draw the
adapter into the bore and install the four retaining
bolts and tighten to the specified torque. Remove the
installation sleeve.
5.) Apply a thin film of compressor fluid to the o-ring and
seal lip of the outer lubricant slinger. Install the outer
slinger over the end of the rotor shaft and push into
the scavenge bore using both thumbs.
6.) Reinstall the scavenge system and drive coupling.
Reinstall the coupling guards before starting the
compressor.