Toshiba 15CV101U - Manual (Page 22)

22
Chapter 2: Connecting your TV
Connecting a digital audio
system
The TV’s DIGITAL AUDIO OUT terminal
outputs a Dolby
®
* Digital or 2-channel
down-mixed PCM (Pulse-Code Modulation)
signal for use with an external Dolby
® Digital
decoder or other external audio system with
optical audio input.
If you have a DTS * decoder or processor, you
can obtain the full benefit of 5.1 channel DTS
encoded soundtracks on DVDs and audio CDs.
You will need:
• optical audio cable (Use an optical audio cable
that has the larger “TosLink” connector and not
the smaller “mini-optical” connector.)
To control the audio:
Note:
• Some audio systems may not be compatible
with Dolby Digital bitstream signals. Older
audio systems that are not compatible with
standard optical out signals may not work
properly, creating a high noise level that
may damage speakers or headphones.
THIS DAMAGE IS NOT COVERED BY
YOUR WARRANTY.
• The DIGITAL AUDIO OUT terminal may not
output some digital audio sources because
of copy restrictions.
* Manufactured under license from Dolby
Laboratories. Dolby and the double-D symbol
are trademarks of Dolby Laboratories.
** Manufactured under license under U.S. Patent #:
5,451,942 & other U.S. and worldwide patents
issued & pending. DTS and the Symbol are
registered trademarks and DTS Digital Out and
the DTS logos are trademarks of DTS, Inc.
Product includes software. © DTS, Inc. All Rights
Reserved.
1 Turn on the TV and the digital audio device.
2 Press on the remote control and open the
Sound menu.
3 Press or to select Audio Setup and then
press .
4 Press or to select Optical Output
Format.
5 Press or to select either Dolby Digital or
PCM, depending on your device.
( “Selecting the optical audio output format”
on Page 41).
6 To save the new settings, highlight Done and
then press
.
To revert to the factory defaults, highlight
Reset and then press
.