Toshiba SD-6915SU - Manual (Page 10)

ENG-10
Description-Rear Panel
Rear Panel
1. DIGITAL AUDIO OUT JACKS
• Use a optical or coaxial digital cable to connect
to a compatible Dolby Digital receiver.
Use to connect to an A/V Amplifier that contains
a Dolby Digital or DTS decoder.
2. 5.1CH ANALOG AUDIO OUT JACKS
• Connect to an amplifier with 5.1ch analog input
jacks.
3. MIXED AUDIO OUT JACKS
• Connect to the Audio input jacks of your
television, audio/video receiver.
4. VIDEO OUT JACK
• Use a video cable to connect to the Video input
jack on your television.
• The Video Output must select the 525i(480i) or
S-Video by setting Video select switch.
5. S-VIDEO OUT JACK
• Use the S-Video cable to connect this jack to
the S-Video jack on your television for a higher
quality picture.
• The Video Output must select the S-Video by
setting Video select switch.
6. COMPONENT VIDEO OUT JACKS
• Use these jacks if you have a TV with Compo-
nent Video in jacks. These jacks provide Pr, Pb
and Y video. Along with Component Video pro-
vides the best picture quality.
• If 525p(480p) Video Out is selected by setting
Video select switch progressive scan mode will
work.
• If 525i(480i) Video Out is selected by setting
Video select switch interlace scan mode will
work.
7. Video Select Switch
Important Note
• Consult your TV User’s Manual to find out if your
TV supports Progressive Scan.
If Progressive Scan is supported, follow the TV
User’s Manual’s instructions regarding Progressive
Scan settings in the TV’s menu system.
• If 525p(480p) Video Output is selected by setting
Video select switch, Video (Composite) and
S-Video will not work.
SURROUND WOOFER
AUDIO VIDEO S-VIDEO S-VIDEO
525i
(480i)
525p
(480p)
OPTICAL
COAXIAL
FRONT CENTER
R L S/W
R L
Pr Pb Y
DIGITAL
OUT
AUDIO OUT VIDEO OUT
1 3 4 5 7
1 6 2