Tascam CD-RW402 - Manual (Page 14)

2 – Using the menu system—SYSTEM menu features
14
TASCAM CD-RW402 Owner’s Manual
SYSTEM menu features
These features determine the settings for either the
whole system, or for the individual drive on which
the settings are made.
Dimmer settings
Individual settings for each drive.
The illumination level of the displays can be set
using this menu option. Adjust this to suit the ambi-
ent lighting levels, personal preference, etc.
1 Press the appropriate MENU key.
2 Turn the MULTI DIAL until SYSTEM MENU?
appears in the display. Push the MULTI DIAL .
3 Turn the MULTI DIAL until DIMMER ?
appears in the display. Push the MULTI DIAL .
4 Turn the MULTI DIAL to set the value to
DIMMER> x? (where x can be from 1 (darkest)
to 8 (brightest).
5 Push the MULTI DIAL .
Meter peak hold
Individual settings for each drive.
When playing back, the meters show the level of the
signal read from the disc. The hold time of the meters
(the time at which the loudest segments stay lit) can
be set.
NOTE
For drive 2, this setting also affects the metering for
recording.
1 Press the appropriate MENU key.
2 Turn the MULTI DIAL until SYSTEM MENU?
appears in the display. Push the MULTI DIAL .
3 Turn the MULTI DIAL until PEAK HOLD ?
appears in the display. Push the MULTI DIAL .
4 Turn the MULTI DIAL to set the value to
P_HOLD> x.xs (where x.x can be from 0.0 to 2.5 in
0.1 second increments).
Alternatively, between the highest and lowest
setting values, there is also a
HOLD setting,
which keeps the highest value displayed (the
rightmost segment is lit) until this value is
changed.
Reset the peak readings by pushing the
MULTI DIAL .
5 Push the MULTI DIAL .
Timer play
Only available from drive 1 and only applies to drive
1.
When power is applied to the CD-RW402 and a disc
is loaded in drive 1, playback can start automatically.
If continuous playback is selected (see “Repeat play-
back” on page 24), playback starts with drive 1, and
when this ends, continues on drive 2.
Drive 2 cannot be selected to start playback
1 Press MENU key 1.
2 Turn the MULTI DIAL until SYSTEM MENU?
appears in the display. Push the MULTI DIAL .
3 Turn the MULTI DIAL until TIMER PLAY ?
appears in the display. Push the M ULTI DIAL .
4 Turn the MULTI DIAL to set the value to
TM_PLAY>OFF? or TM_PLAY> ON? .
5 Push the MULTI DIAL .